jethro13
jethro13
I used a 150ft roll of 160psi water line bought at Manards cut to the required lengths to bridge across the ponds and stream
18 inch lengths of 5/8'' rebar was pounded in at an angle for the tubing to slide over. Each tube was numbered with a soldering iron
net was fastened to the ground with a 16 penny nail incerted through a sheetmetal washer with a rubber protector made from pond liner
this shows the size of the netting

18 inch lengths of 5/8'' rebar was pounded in at an angle for the tubing to slide over. Each tube was numbered with a soldering iron

net was fastened to the ground with a 16 penny nail incerted through a sheetmetal washer with a rubber protector made from pond liner

this shows the size of the netting

